1. Home
  2. Telescopic boom crane

Crane types

Telescopic boom cranes

Telescopic boom cranes are the hydraulic cranes: rough terrain, all terrain and truck-mounted. The boom changes length at the controls, so the operator has one more variable to track than on a lattice crane.

The short answer

A telescopic boom crane has boom sections that extend and retract hydraulically. OSHA requires a boom length indicator on it, a boom angle or radius indicator, and an anti-two-block device that automatically prevents damage on cranes built after February 28, 1992. OECP sorts them by size: small under 22 tons, medium 22 to 75 tons, large over 75 tons.

Checked November 2026 against the text of 29 CFR 1926.1416, 29 CFR 1926.1415 and the OECP Crane Operator Candidate Manual.

What OSHA requires on a telescopic boom

Operational aids in 29 CFR 1926.1416
Boom length indicatorRequired on telescopic booms, unless the rated capacity does not depend on boom length. If it fails: use marks on the boom, a calculation or a measurement
Boom angle or radius indicatorRequired. If it fails: measure the radius or the boom angle
Anti-two-block deviceOn cranes built after February 28, 1992, a device that automatically prevents damage from two-blocking. If it fails: mark the cable and use a spotter
Load weighing device, LMI or limiterOn cranes built after March 29, 2003 and rated over 6,000 pounds
Outrigger position sensorOn equipment built after November 8, 2011
Boom stopsNot required on hydraulic booms

Sources: 29 CFR 1926.1416 and 29 CFR 1926.1415.

Telescoping out with the block near the tip is a common cause of two-blocking. Two-blocking and the anti-two-block rules.

8 practice questions on telescopic boom cranes

Pick an answer to see whether you are right and why. These are original practice questions from the Crane Exam Prep question bank, not actual exam questions.

  1. Technical Knowledge

    1. A telescoping (hydraulic) boom differs from a lattice boom in that the telescoping boom…

    Show answer

    Answer: B. Extends and retracts hydraulically and is generally heavier per foot. Telescopic booms extend hydraulically and weigh more per foot; lattice booms are lighter, pinned sections raised by the boom-hoist rope and pendants.

  2. Mobile Crane Essentials

    2. If the outriggers are not fully extended, which load chart must be used?

    Show answer

    Answer: D. The on-rubber chart or the chart specified by the manufacturer. With outriggers not fully extended, you must use the rubber (on tires) chart or the chart the manufacturer specifies.

  3. Technical Knowledge

    3. On a telescopic crane with multiple telescoping levers, how must the boom sections be extended for the load chart to apply?

    Show answer

    Answer: A. Equally, because the chart is based on equally extended sections. Load ratings assume a specific section geometry. Running one section out alone concentrates bending in that section and voids the chart values.

  4. Crane Types

    4. Rough terrain crane capacities are generally greater over the…

    Show answer

    Answer: C. Front. RTs typically rate highest over the front.

  5. ASME B30.5 (Mobile Cranes)

    5. According to ASME B30.5, a wheel-mounted crane on outriggers fully extended and set with tires off the supporting surface is rated at:

    Show answer

    Answer: A. 85% of the tipping load. Table 5-1.1.1-1 permits 85% for wheel-mounted cranes with outriggers fully extended and set and tires off the supporting surface.

  6. Crane Types

    6. A telescopic boom is extended and retracted by:

    Show answer

    Answer: C. Hydraulic cylinders inside the nested boom sections. Telescopic (hydraulic) booms use internal cylinders to extend nested sections, giving fast setup without assembling pinned inserts.

  7. Technical Knowledge

    7. In a hydraulic crane, the component that keeps a raised boom or outrigger jack from drifting down if a hose bursts is the…

    Show answer

    Answer: A. Counterbalance/holding valve (integral check valve). A counterbalance/holding (check) valve holds the cylinder against drift and is required on outrigger and boom-hoist jacks to prevent uncontrolled lowering if a hose fails.

  8. Crane Types

    8. Unless the manufacturer says otherwise, truck cranes generally have NO capacity over the…

    Show answer

    Answer: C. Front. The front quadrant is typically a no-lift zone on truck cranes.

Free OECP practice test

25 questions, no sign-up, every answer explained.

Start now

How OECP classes telescopic boom cranes

One mobile crane written covers boom truck, lattice boom and telescopic boom. The practical is taken by crane type, and the telescopic type is split by size.

OECP mobile crane types
TypeSize
Boom truckIts own type
Telescopic boom, smallUnder 22 tons
Telescopic boom, medium22 to 75 tons
Telescopic boom, largeOver 75 tons
Lattice boomIts own type

Source: OECP Crane Operator Candidate Manual.

Reading a telescopic load chart

A telescopic chart has more ways to go wrong than a lattice chart, because the configuration changes during the lift. The practice questions above touch the main ones:

  • Boom length between columns. Follow the chart's own note. Many say to use the next longer length.
  • Outriggers not fully extended. You are on a different chart, or no chart at all.
  • Unequal extension. Ratings assume the sections are extended the way the manufacturer specifies.
  • Over the front, side and rear. Capacities change with the work area.

How to read a crane load chart, step by step.

FAQ

Telescopic boom crane questions

What is a telescopic boom crane?
A crane whose boom is made of sections that slide inside one another and extend or retract hydraulically. Rough terrain, all terrain and truck-mounted hydraulic cranes are all telescopic boom cranes.
Does OSHA require a boom length indicator?
Yes, on telescopic booms, unless the crane's rated capacity does not depend on boom length. It is a Category II operational aid.
How does OECP classify telescopic boom cranes?
By size: small is under 22 tons, medium is 22 to 75 tons and large is over 75 tons. Boom trucks are their own type.
Do telescopic boom cranes need boom stops?
No. OSHA's boom stop requirement has an exception for hydraulic booms.
Is the telescopic boom written exam separate?
No. OECP uses one mobile crane written exam for boom truck, lattice boom and telescopic boom. The practical is separate for each type.
Are these real exam questions?
No. They are original practice questions written from the OSHA rules and ASME B30 standards that crane exams draw on. OECP does not release its questions, and this site is not affiliated with OECP or the IUOE.

Keep going

One free practice test shows you where you stand.

25 questions. No sign-up. Every answer explained.

Start the free practice test
More practice questionsFree account, no card
Open the app